Recording Studio9

Once the first layer of plasterboard is installed, I sealed all the edges with silicon. This will limit air movements and help with soundproofing. Next,...

Time to install the internal plasterboard. This is the first of the two layers. First I complete the ceiling, then all 4 walls. Not as...

Now that I have both layers of SoundScreen© acoustic insulation batts installed, time to run another room acoustics analysis, to measure the room response. Quite...

Installing the outer door. This is one of the important steps in the soundproofing process. To make sure I have the minimum and correct door...

Time to sand down the outer Fiber-Cement cladding board plaster. Took me a whole day to sand it down. Now ready for painting preparation. I...

I took the opportunity to try out and do a recording in my new unfinished studio, recording Congo, Bongos, shakers and hand clapping. Since I...

Time to work on the internal SoundScreen insulation batts, covering all four walls and the ceiling...

In this episode, I install, with the help of my elder son, all the outside wall cladding with Blueboard Fibre-Cement panels. Once all are in...

Most audio mixers and some audio interfaces do have INSERT option. These are TRS 6.5mm sockets. If you’re not sure what they are and how...

I finally get to finish off the roofing and the corner panels....

I finally find and decide on the Exhaust Fan. I hope it will end up being a good choice. Working on the doors, and I...